Audiovox Car Security System APS 996a Dokumentacja Pobierz pdf (Strona 8)

Wiring the Harness

Red Wire: +12V Input (DB25 Pin 1)

Connect this wire to the +12VDC constant source found at the ignition harness

connector C59 pin 6 located under the driver side dash. It is the White wire. Use

a fused connection or tie in after the car alarm system fuse.

Black Wire: Gnd (DB25 Pin 2)

Connect this wire to Chassis ground. Remove the driver’s side center console

cover and use one of the relay mounts to attach a ground lug. Make sure the

ground wire is FIRMLY attached to the bare metal surface.

White Wire: Tonneau Open Trigger (DB25 Pin 5)

Connect this wire to one of the extra channels from your car alarm. In my system

I used the Dark Blue wire that is the APS-996a Channel 3 Output.

Yellow Wire: Hardtop Close Trigger (DB25 Pin 6)

Connect this wire to one of the extra channels from your car alarm. In my system

I used the Light Blue / Green wire which is the APS-996a Channel 5 Output.

Orange Wire: Tonneau Close Trigger (DB25 Pin 7)

Connect this wire to one of the extra channels from your car alarm. In my system

I used the Light Blue / Black wire which is the APS-996a Channel 6 Output.

Green Wire: Hardtop Open Trigger (DB25 Pin 8)

Connect this wire to one of the extra channels from your car alarm. In my system

I used the Light Blue / Red wire which is the APS-996a Channel 7 Output.

Blue Wire: Tonneau Open Actuator (DB 25 Pin 10)

The D48 connector is located under the control switch garnish. Find pin 10 on

the connector. It will have 12V applied when the tonneau switch is operated to

the open position. Although the manual states this wire is Light Green / Black I

found it to be Green in my car.

Purple Wire: Tonneau Close Actuator (DB 25 Pin 11)

The D48 connector is located under the control switch garnish. Find pin 9 on the

connector. It will have 12V applied when the tonneau switch is operated to the

close position. Although the manual states this wire is Black / White I found it to

be Black in my car.

Brown Wire: Hardtop Open Actuator (DB 25 Pin 12)

The D48 connector is located under the control switch garnish. Find pin 3 on the

connector. It will have 12V applied when the hardtop switch is operated to the

open position. Although the manual states this wire is Grey / Red I found it to be

Yellow in my car.

JNS Engineering 8 3/28/2009

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 30 31

Brak uwag

Audiovox Car Security System APS 996a Dokumentacja Strona 8