Audiovox pro 9276 Instrukcja Użytkownika Pobierz pdf

128-7855

1 of 20

The selectable features can be set manually as explained below, or with the RF feature programmer.

To set features using the RF programmer, follow the instructions packaged with the programmer.

Factory default settings are indicated by bold text.

Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code.

Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.

NOTE: Keyless Entry Models with no horn output will Flash the Parking Lights instead of chirp where chirp is indicated.

Also, No data will be indicated if a feature is not available for a particular model. The unit will enter the feature but no selection will be available.

RF Programmable Feature Bank 1 Is For Transmitter Programming See Transmitter Programming Guide.

RF Programmable Features Bank 2 Is Alarm Selectable Features:

Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps 5 Chirps 6 Chirps

1st DoorL/UL 1 Sec. 3.5 Sec. 1 Sec L, Dbl. U/L Dbl L, 1 Sec UL Dbl L, Dbl UL 1 S l/350mS ul

2nd Accy Lock Auto Lock On Auto Lock Off

3rd Accy. UL Auto UL Dr. Auto UL All Auto UL Off `

4th Headlights Not Available

5th Passive Locks Not Available

6th Pass/Act Arm Not Available

7th Siren/Horn Not Available

8th Horn Chirp 10mS 16mS 30mS 40mS 50mS

9th O/R Method Not Available

10th 2 Step U/L On Off

11th Chp Del Tx On Off

12th Vlot Sense/Hd Wire Not Available

13th Trigger Circuits Not Available

14th L/UL Poll Not Available

15th Aux Ch 5 Sel Pulse Push & Hold 10 Sec 20 Sec Latch On/Off Hold 3/S For O/P

16th Aux Ch 6 Sel Pulse Push & Hold 10 Sec 20 Sec Latch On/Off Hold 3/S For O/P

17th Aux Ch 7 Sel Pulse Push & Hold 10 Sec 20 Sec Latch On/Off Hold 3/S For O/P

18th Trigger Delay Not Available

When using the RF programmer, enter the program mode as follows:

Turn the ignition on.

Press and release valet switch 3 times;

turn ignition off then on.

Press and hold valet switch for 5 seconds.

Siren and or lights chirp/flash 2 times indicating access to RF feature program mode.

Model PRO-9276

Installation Manual

1 2 3 4 5 6 ... 19 20

Podsumowanie treści

Strona 1 - Model PRO-9276

128-78551 of 201The selectable features can be set manually as explained below, or with the RF feature programmer.To set features using the RF program

Strona 2

128-785510 of 2010YELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass OutputNOTE: You must disconnect the ignition input of the alarm from

Strona 3

128-785511 of 2011C. GM VATS Key Override:If the vehicle has the General Motors VATS system installed, you will need to bypass the system while the ve

Strona 4

128-785512 of 2012WIRING THE 4 PIN AUXILIARY OUTPUT HARNESSThe auxiliary 4 pin connector provides low current outputs to control various functions in

Strona 5

128-785513 of 20135 Pin Accessory Output HarnessDark Blue Wire : Delayed 300 mA Pulsed Output/Channel 3The dark blue wire pulses to ground via an ind

Strona 6

128-785514 of 2014WARNING: Connecting the light blue/black to the high current circuits, will damage the control module.Connect the light blue/black

Strona 7

128-785515 of 2015NOTE: Once selected, 2 or 4, this timer interval will remain in memory until it is manually changed. Tochange, the above sequence wi

Strona 8

128-785516 of 2016TESTING YOUR INSTALLATION:WARNING!! The following procedure must be performed after the installation of an Audiovox RemoteStart Dev

Strona 9

128-785517 of 2017The information concerning the Mechanical Neutral Safety Switch provided below will help you to deter-mine if the vehicle you are wo

Strona 10 - 10 of 20

128-785518 of 2018Method 1 will allow the safety required for the remote start unit and prevent the vehicle from starting whilein any gear other than

Strona 11 - 11 of 20

128-785519 of 2019NOTE: A second 4002 series diode may be required to maintain the integrity of the hood open, shut downcircuit. If this is the case,

Strona 12 - 12 of 20

128-78552 of 202To program these selectable features;Action System ResponseTurn ignition on No responsePress and release the valet switch 3 times 1 Ch

Strona 13 - 13 of 20

Strona 14 - 14 of 20

128-78553 of 203To exit program mode, turn ignition off, or press and release valet switch.RF Programmable Features Bank 3 Is Remote Start Selectable

Strona 15 - 15 of 20

128-78554 of 204Action System ResponseTurn ignition on No responsePress and release the valet switch 3 times 1 Chirp - LED 1 flashWithin 3 seconds, tu

Strona 16 - 16 of 20

128-78555 of 205This Remote Start System is designed for use with Automatic Transmission Vehicles Only! The unitprovides wait to start input for glow

Strona 17 - 17 of 20

128-78556 of 206IMPORTANT!DO NOT PLUG THE SIX PIN MAIN POWER HARNESS OR THE MULTI PIN INPUT / OUTPUT HARNESSINTO THE CONTROL MODULE UNTIL ALL CONNECTI

Strona 18 - 18 of 20

128-78557 of 207SEE NEUTRAL START SAFETY TEST FOR FURTHER DETAILS.BLUE WIRE: Ignition 1 OutputConnect this wire to the ignition 1 wire from the igniti

Strona 19 - 19 of 20

128-78558 of 208WIRING THE 4 PIN ALTERNATE IGNITION HARNESSORANGE/BLACK Wire: Parking Brake InputThis wire is used only when the turbo timer mode, Ban

Strona 20 - 20 of 20

128-78559 of 209WIRING CONNECTIONS: 12 Pin Input / Output HarnessBlack Wire: Chassis Ground Source. Connect the Black wire to a known vehicle ground s